Part of the Oxford Instruments Group
Expand
Webinar
PTIQ Software Upgrade

28 October 2020

8.30am BST & 3pm BST


About the Webinar

PTIQ is the latest intelligent software solution for PlasmaPro and Atomfab processing equipment.

In this webinar, we'll show you the benefits of upgrading your system control software, and showcase the key features of PTIQ, including display options; maintenance; recipe creation and data analysis tools.

  • Exceptional level of responsive system control
  • Optimise system and process performance
  • Different levels of software to suit your requirements
  • Brand new intuitive layout and design

 

FAQs

When is this available?

PTIQ is available now.

Since February 2020, systems have been quoted, are being built, and leaving the factory with PTIQ. At present, around 75% of our product line is utilising PTIQ, meaning PlasmaPro 100, 80, and 800 are currently set up for the new software. Our new ATOMFAB system also includes PTIQ.

What are the hardware upgrades that we need to have to be able to upgrade to PTIQ?

This will be evaluated case-by-case, but there are some minimum specifications we need for PTIQ to work on an existing set of hardware:

  • 1080p widescreen monitor
  • Relatively new PLC (internal compute module inside the process chamber: an X20 variety and specifically a 1584 module that has the larger memory. This is typical of most systems installed within the last 2 years).
  • Some minor ancillary modules (e.g. Profibus module)
  • At least 8GB of computer memory

If I have an etch system and a deposition system, will it be the same software and work the same way?

Yes. This was an important goal for the new software to give a consistent look and feel and to find the common actions needed to operate all our systems.

There will be a few notable differences, but they relate to the specific technologies involved. This means that, whether the modules exist on the same cluster configuration or are side by side as two separate single module tools, the software will be the exact same.

Does this work with cluster systems?

We support our three families of products with PTIQ: open-load, single module and out cluster systems. All three types of system have the same look and feel and operate in a similar manner.

Is PTIQ touch screen compatible?

We have designed the software with the view that it will be controlled via a touchscreen, ensuring that with a 24” touchscreen that the active areas will be at least 1cm square. Although the SEMI E95 standard is no longer active, it does still serve a purpose in helping to make a touchscreen operator interface for Semiconductor Capital Equipment.

Is PTIQ multi-monitor compatible?

This is on our short-term roadmap. We built the software from the ground up with dual monitor support from the beginning, but this is not yet available to be activated in the software as this feature needs a little more work before it is complete.

With existing PC4500 software, LogViewer log files can be viewed on another PC if manually transferred to another PC. It would useful if remote users could more easily access data files and analyse it. What will the new software offer?

We will soon be packaging the Datalog viewer as a standalone product so that it may be installed on a separate PC. We are looking to make the process of transferring files much easier.

Can a parameter (e.g. RF) be graded from start and end value through a loop?

This feature is in the process of being developed as we seak to support the more advanced deep silicon etch processes. Our implementation will be available for all process modules when it is released, not only the Estrelas tool.

Do you have a simulator of this software that we can install in our personal computer for testing or training?

We have a simulator/emulator that can be used for this purpose. For example, it does a very good job of emulating the hardware including some simple algorithms to emulate the physics involved in pressure control.

Related Content